Technology
Comes in black and white, about twenty-seven inches wide--a heavy stiff material, smooth on one side and rather rough on the other. It is more commonly used for hat foundations than any other fabric. There is also a summer buckram, lighter in weight and smooth on both sides.
Comes in black and white, about twenty-seven inches wide--a heavy stiff material, smooth on one side and rather rough on the other. It is more commonly used for hat foundations...
2. Chapter 2Place corner of velvet at front of brim on top side (smooth side). Edgewire and headsize wire should always be on top of brim. Turn velvet over edge of brim and pin. Stick pins...
3. Chapter 3Lay the pattern on the neteen in such a way as to bring the bias where the greatest amount of roll is to be, then cut making the same allowances as if cut from buckram. This mat...
4. Chapter 4Place wire firmly and squarely between the jaws of the pliers at the point where they cut and press straight down. Be sure to cut with the first attempt; otherwise, if the wire...
5. Chapter 5A round crown is one which rounds from tip to base. First straighten, measure, and cut four sticks of brace wire, as for square crown, of the ordinary length, allowing for finis...
6. Chapter 6Great care and patience must be exercised in covering a hat with straw braid. The lines which are to be emphasized should be carefully studied, as there are several methods used...
7. Chapter 7Cut from a piece of velvet, satin, or any fabric which is to be used, a bias strip one and one-half inches wide and of the desired length. This must be on a true bias, which is...
8. Chapter 8Flowers may be made from almost any fabric--satin, velvet, georgette, maline, ribbon, soft leather, oilcloth, yarn, and chenille. A scrapbag for odds and ends should always be k...
9. Chapter 9BRIM--Brush well to remove all the dust. If the brim is too wide, a few rows of braid may be removed from the edge, and the edge refinished with one or more rows of ornamental b...